2022-08-26
Everybody has seen the traffic signal pole, because the traffic on the road is more and more dependent on it, and its installation problem has also caught more and more people’s attention. If there is something wrong with the installation and the traffic signal pole falls, it will be a very troublesome thing. Therefore, I'm going to tell you a little bit about how to install the traffic signal pole.
1. Design the installation drawing before installation
The installation of the traffic signal pole should be guided according to the installation drawing. This is also an essential step because it can reduce many false conducts in installation.
2. Select installation location
After selecting a good installation location, the chosen ground can be excavated. The size should be moderate. After excavation, the ground can be tamped according to specific conditions.
3. Install the pole body
The most important thing in this step is that the pole body of the traffic signal pole should be vertical to the ground, and the error should not be more than 0.5% degree. After installation, the ground resistance should also be tested. In principle, the ground resistance should not be more than 4 ohms, and the wires generally does not go through the pole body.
4. Pour the reinforced concrete
The standard of the steel reinforcement and cement shall conform to the corresponding national technical standard. The injection surface shall be flat and the foundation bolt shall be installed after it is dried.
In the past few years, Sinowatcher's market has expanded to more than 80 countries, including Europe, South America, Southeast Asia, Australia, South Africa and the Middle East. We have successfully completed programs of traffic lights and road safety in many parts of the world, and we welcome everyone to work with us to keep our roads safe.
