What requirements should the traffic sign board need to meet?

With the advancement of urbanization, there are more and more motor vehicles on the road, which also brings certain pressure to road driving. Therefore, many traffic facilities can be seen at each road entrance. All kinds of road traffic signs play a very important role in the safe driving of the road. In the setting of traffic signs, the surface color is more gorgeous, It can give pedestrians a good visual impact. You can see the traffic signs at the first sight and drive according to their instructions. Especially at night, via the lamp illumination, the surface signs can be seen through the reflection, which effectively improves people's discrimination ability and causes the driver's vigilance. It can provide great convenience for people's driving in the dark.


1. All the signboards that need to be installed must be confirmed by the technical engineer, and the product quality must be strictly tested.


2. After the arrival of machinery and equipment on the spot, the management methods of traffic sign setting, road barrier and other safety equipment should be well used for non motor vehicle and traffic travel, and the actual operation standard engineering construction should be strictly implemented, in order to ensure the safety of the staff on-the-spot with a greater limit, avoid the occurrence of safety accidents as far as possible, and ensure the safe construction.


3. Strictly implement the provisions of engineering drawings and set the location of the traffic direction measurement mark.


4. The sign plate shall be fixed on the support according to the connecting parts such as dragging anchor bolts and hoops. The ratio of height to width between the lower edge of single column sign plate and the ground shall be 250cm.


5. After basic measurement of traffic sign, the excavation of the back foundation pit shall be considered in many aspects of the address set on the engineering drawings, and the formwork, building reinforcement, concrete pouring shall be carried out in accordance with the regulations. The positions of foundation screws and base flange shall be appropriate and exceed the required design elevation.


6. The construction of sign support point structure shall be carried out after the strength of basic concrete exceeds the specification and the approval of the supervision engineer is obtained. The flange of the support and the basic base flange of the concrete should be level and close, and the anchor screws should cooperate with each other properly. After tightening the anchor bolts, the support should not be skewed.


7. After the sign board installed, check and adjust the flatness and aspect ratio of the sign board to make it exceed the requirements.


8. After the installation of traffic signs, it is necessary to carry out relative cleaning work to keep the surface clean and elegant.


LED Warning Lights


Related Product

  • Contactless Pedestrian Push Button Contactless Pedestrian Push Button
    Capacitive button and mechanical button combined in a solid moduleHumanization design with back-light words and voice prompt Real-time counting for the remaining red and green time IP65 protection level
  • 200mm/300mm Red Cross + Green Arrow One Unit Traffic Light 200mm/300mm Red Cross + Green Arrow One Unit Traffic Light
    Transparent polycarbonate optical lens – impact resistant Anti-phantom effect minimized, optimal viewing angle High intensity LED light source – low energy consumption Long life cycle – more than 80,0...
  • 200mm/300mm Square Countdown Timer Traffic Light 200mm/300mm Square Countdown Timer Traffic Light
    Application – junction traffic signal counting Available in learning, triggered or communicative version Ability to be synchronized with any traffic signal controllerWide operating voltage adapting to ...